Neunaber Seraphim Shimmer v2 Reverb Effects Pedal Black

Description

Neunaber´s Seraphim Shimmer v2 reverb effects pedal can give your tone a little atmospheric sparkle or a full synth-pad vibe. You can switch on the fly between this and the Wet Reverb for which Neunaber is famous. But you also want to keep it simple—less time fiddling with knobs and more time playing. And you want something that doesn’t take up a lot of space on your pedalboard or require a lot of power from your supply. The Seraphim Shimmer v2 is everything you loved about the original, plus more.

Features

• Add or remove the shimmer layer from the reverb—a long press of the footswitch seamlessly transitions between shimmer and reverb only
• Mono input and output makes setup quick and simple—easy access to inputs and outputs makes this pedal perfect for on-the-go use
• Analog dry signal for low noise and zero latency—maintain the integrity of your source tone
• Small footprint with top jacks, the Wet Reverb is pedalboard-friendly—you can easily fit the Wet in any setup, no matter how tight
• Powered from a standard 9V pedal power supply (not included), the Seraphim Shimmer draws less than 100mA and can be powered by your existing pedalboard’s power supply—no need to run a separate power adapter or free up a power port for a hungry, high-current device
• Manufactured in Orange County, California

Specs

Electrical

• Nominal input level:–10dBV, instrument level
• Input impedance: 1 mohm
• Frequency response, dry/bypassed: 20Hz–30kHz, +/–1dB
• Total harmonic distortion, dry/bypassed: 0.01%

Power

• Input: 9–12V DC, 100mA
• Connector: Center-negative, 5.5 mm OD x 2.1 mm ID

Dimensions (LxWxH)

• 4.6" x 2.6" x 1.9" (115 mm x 64 mm x 46 mm)

Weight

• 6.7 oz. (190 g)